HVAC REPAIR PUTTY (6.5 oz./set) 19770

Directions for use

Surface Preparation

Proper surface preparation is essential to the success of any epoxy application. In all cases the surface should be clean, dry, free from oils, and rough.

1. Remove all oils, dirt and grease by means of a strong cleaner/degreaser (Devcon® Surface Cleaner is suitable for this process).

2. Roughen the surface by grit blasting (8-40 mesh grit) or grinding. A 75-125 micron profile is desired for most applications, including defined edges (do not ‘feather edge’ epoxy).

Note: For metals exposed to sea water or other salt solution, grit blast and high pressure water blast the area, then leave overnight to allow any salts in the metal to ‘sweat’ to the surface. Repeat blasting to ‘sweat out’ all soluble salts. Perform chloride contamination test to determine soluble salt content (should be no more than 40ppm)

3. All abrasive preparation should be followed by another cleaning to remove any remnants from that process.

4. Repair surface as soon as possible to eliminate any changes or surface contaminants.